PROTIX ® Range
Antiwearing concretes
REYMA-Reotix has developed a range of refractory concretes with excellent mechanical strengths both under bending and compression, and very low erosion loss values at both high and low temperatures, even below 100C and in the presence of acids.
For its monolithic nature they present several significant advantages over traditional anti-wear plates/tiles and can be applied by different systems and with the possibility of several anchoring systems.
The main reasons for the use of the antiabrasion refractory concretes are to avoid inleaking (false) air entry which decreases energy efficiency of the industrial process, as well as for environmental protection.
- Quick installation & dry-out.
- Resistant to abrasion & wear.
- Very low sinterisation temperature.
- Very high mechanical resistance both against flexion and erosion in a wide range of temperatures.
- Applicable in great surfaces, free of geometric or joints restrictions and in different thicknesses depending on the area.
- Short application time with minimum staff, no need of special machinery.
- High application performance, with low application cost and easy maintenance.
- Different application systems: vibrocast, self-flow, gunning, patching.
- Different types of anchors: rod or plate, steel wire mesh, hexagonal or hex-mesh, etc.
- Suitable to be reinforced with steel fibres (needles).
- Cualquier área sometida a alta erosión a bajas, medias o altas temperaturas
- Conducto de aspiración de polvos del H.E.A.
- Cámara de postcombustión o de decantación de polvos.
- Conducto precalentador de chatarra tipo SHAFT.
- Cualquier área sometida a alta erosión a bajas, medias o altas temperaturas.
- Ciclones de desempolvado y de etapas superiores. .
- Conductos entre ciclones, resbaladeras de harina.
- Silos y molinos, separadores de molinos.
- Enfriadores de parrillas: conducto de captación de polvos, tolvas de descarga, zona cadenas y machacadora.
- Compuerta o válvula de aire terciario.
- Salida de humos y zona de carga de material en horno de cubilote.
- Líneas de transferencia.
- Escudos ciclones y lanzas en FCC.
- Zona de recepción de cenizas ácidas.
- Tolvas y ceniceros.
- Cyclone Mills
- Separators
- Grate Cooler Dust Duct
- Conveyor Transport Area
- Satellite Coolers
- Chamber Entrance
- Inlet Ramp, Tray and Arch
- Ducts in Cyclones, Cyclones Angular Point (Bull-Nose)
- Tertiary Air Damper
- Maximum Wear Areas